You Can Repair Your Canon SD Series Lens Barrier Covers Yourself!

So many different people have asked us about fixing the built in lens covers/barriers/flaps on their Canon Powershot SD series digital cameras that I’ve gone ahead and written some instructions. The barrier kit on most Canon PowerShot SD series cameras is a little tricky but not impossible to replace yourself. You will need patience, a good eye and a steady hand as well as a small screwdriver. We use dental picks, they work great!

To start, you will need to turn on the camera and extend the lens, then open the battery door to turn off the camera and keep the lens out. This allows you to easily work on the lens barrier assembly.

First the part we need is the ‘barrel drive ring’, it’s the ring with the small piece that sticks down into the lens. Some cameras don’t have one, so if there isn’t one in your kit then your camera doesn’t need it. Make sure it rotates slightly once it has been inserted, otherwise it’s not in properly and can jam the lens.

Next are the springs and flaps. Put one spring on each of the flaps, there are little tabs to hold them on. They are TINY, they are hard to hold and if you drop it… lets just say DON’T drop it on the carpet, ok? We do have just the springs available for purchase, but please try not to lose them.

Carefully put the cover or ‘flap’ in the hole with the spring pointing towards the post where the other end will connect, and then with something with a tiny and pointy tip (we use dental picks!) gently grab the loop of the spring and stick it on its post.

Do this with the flaps in the open position, they will stay in place if you get them seated properly. If everything pops off, just start again. Do not stretch out the springs as they must remain tight or nothing will work properly.

Then gently put on the barrier cover, it’s a flat plastic ring. There are tabs on the barrier cover, they match up with little slots on the lens and it locks into place. Be gentle, don’t force anything too hard or you will break it and the parts will not hold it place.

Now it’s time to test your skills! Put in the battery (cross your fingers) and press the power button! Is it working? Did it go flying across the room with a cute little *SPROING!* and maybe all the parts scattered all over the place? Yeah I hope not, but I’ve been there myself so you’re not alone.

Once you have it working smoothly …you’re almost done with your first digital camera repair!

Next put the dual sided tape on the barrier cover. VERY IMPORTANT: Peel the tape off the yellow backing paper but DO NOT remove the paper from the side that is cut to match the shape of the tape!! If you take off the small paper part it will ruin the tape because it will fold and stick to itself. Bye bye tape!

The tabs fold over the edge, don’t let them stick out or the lens cover won’t fit and the lens will jam. Line up the tape tabs, starting at the 11 o’clock position and then fold down the tabs and press them in.

Now put on your chrome or black lens cap, line up the cap with the small indentation at the bottom, you’ll see how it goes on easily.

Fire up the camera again and admire your handywork! Congratulations you now know more about Canon camera repair than the Geek Squad, and they told you it would be two hundred dollars and take 3-4 weeks to repair. Whatever Geek Squad… Whatever.

Hmm… I think I’m seeing the beginning of something big here; truely affordable Canon camera repair!

Related Posts

Underwater Digital Cameras Underwater Digital Cameras: Brief guide for Buying Underwater digital cameras are a special designed digital...
Canon Powershot Digital Cameras Looking for a digital camera to take great pictures and high quality videos that can...